Návod k použití SONY M-800V

[. . . ] t The cassette is being inserted in the wrong way. t The batteries have been inserted with incorrect polarity. t >PAUSE is slid in the direction of the arrow. t The AC power adaptor is connected to the unit only and you are going to use the unit on batteries. [. . . ] Set VOR to H (high) or L (low) depending on the conditions. REC lamp (M-850V only) REC/BATT lamp (M-800V only) VOR FAST PB (M-850V only) Tape counter BATT/E lamp (M-850V only) CUE MARKER (M-850V only) > PAUSE z CUE/ REVIEW TAPE SPEED Tx DIR To monitor the sound Connect an earphone to the EAR jack. The monitor volume cannot be adjusted by VOL. To prevent a cassette from being accidentally recorded over (see Fig. B-(c)) Break out and remove the cassette tabs. To reuse the cassette for recording, cover the tab hole with adhesive tape. (b) Recording cue markers (M-850V only) While recording, you can record a special signal on the tape to mark a specific position. At the desired position, press CUE MARKER to record a signal. The REC lamp flashes and a signal will be recorded on the tape. If you want to record a signal longer than that, press CUE MARKER as long as you want. During cue and review, you will hear the beep sound at the signal position. During playback with the headphones plugged in, you will hear the signal with low frequency sound at the signal position. Notes · We recommend recording cue markers when there is a break in the sound. Non-standard 1 Press the reset button of the tape counter. Note The number in the tape counter will increase when playing back the forward side, and decrease when playing back the reverse side. * If you leave the unit after the tape has been wound or rewound, the batteries will be consumed rapidly. Be sure to depress Tx. Note If the tape is completely wound or rewound while searching forward/ backward during playback (CUE/REVIEW), the CUE/REVIEW switch may not return to the center position when you release the switch. In this case, push back the switch to the center to start playback. 2 Approx. 2. 5 mm 3 (d) to the wall outlet E 4 Press Tx, insert a standard microcassette with the side to start recording facing the lid, and then close the lid. 2. 4 cm for optimum sound (recommended for normal use): A 30-minute recording can be made using both sides of the MC-30 microcassette. 1. 2 cm for longer recording time: A 60-minute recording can be made using both sides of the MC-30 microcassette. To record on both sides Slide DIR so that the FWD indicator turns green. Recording will start form the side facing the cassette holder window (forward side) and switches automatically to the reverse side at the end of the side (Auto Reverse). Note Make sure the tabs on both sides are not removed. Even if only the tab on the reverse side is removed, recording cannot be made. Maintenance (see Fig. [. . . ] For AC operation, use the AC power adaptor recommended for the unit. For battery operation, use two R03 (size AAA) batteries. On the unit ·Use only the (standard microcassettes) with this unit. Non-standard cassettes cannot be used because their "L" dimension (see illustration) is different (see Fig. [. . . ]